Qinq Commands - D-Link DES-3028 Cli Reference Manual

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
The QinQ commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
enable qinq
disable qinq
show qinq
config qinq ports
show qinq ports
Each command is listed, in detail, in the following sections.
enable qinq
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable QinQ:
DES-3028P:4#enable qinq
Command: enable qinq
Success.
DES-3028P:4#
disable qinq
Purpose
Syntax
Description
Parameters
Parameters
[<portlist>|all] {role [nni | uni] | tpid [<hex 0x0 – 0xffff>}
{<portlist>}
This command is used to enable the QinQ mode.
enable qinq
This command enables QinQ mode.
When QinQ is enabled, all network port roles will be NNI port and their
outer TPID will be set to 88a8. All existing static VLANs will run as SP-
VLAN. All dynamically learned L2 address will be cleared. GVRP and
STP need to be disabled manually.
If you need to run GVRP on the switch, firstly enable GVRP manually.
The default setting of QinQ is disabled
None.
Only Administrator-level users can issue this command.
This command is used to disable the QinQ mode.
disable qinq
This command disables QinQ mode.
All dynamically learned L2 address will be cleared. All dynamically
registered VLAN entries will be cleared, GVRP will be disabled.
If you need to run GVRP on the switch, firstly enable GVRP manually. All
existing SP-VLANs will run as static 1Q VLANs. The default setting of
QinQ is disabled
None.
270
38
Q Q C
IN OMMANDS