D-Link DES-3028 Cli Reference Manual page 305

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config lldp dot1_tlv_protocol_identity
Parameters
Restrictions
Example usage
To configure the protocol identity TLV from the outbound LLDP advertisements for all ports:
DES-3028P:4# config lldp ports all dot1_tlv_protocol_identity
all enable
Command: config lldp ports all dot1_tlv_protocol_identity all
enable
Success.
DES-3028P:4#
config lldp dot3_tlvs
Purpose
Syntax
Description
Parameters
and it is enabled to be advertised, then this protocol identity will be
advertised.
<portlist>  Specified a range of ports to be configured.
all  To set all ports in the system, you may use the "all" parameter.
dot1_tlv_ protocol_identity  This TLV optional data type indicates
whether the corresponding Local System's Protocol Identity instance will
be transmitted on the port. The Protocol Identity TLV provides a way for
stations to advertise protocols that are important to the operation of the
network. Such as Spanning Tree Protocol, the Link Aggregation Control
Protocol, and numerous vendor proprietary variations are responsible for
maintaining the topology and connectivity of the network. If EAPOL,
GVRP, STP(including MSTP), and LACP protocol identity is enabled on
this port and it is enabled to be advertised, then this protocol identity will
be advertised. The default state is disable.
Only Administrator-level users can issue this command.
Used to configure an individual port or group of ports to exclude one or
more of IEEE 802.3 organization specific TLV data types from outbound
LLDP advertisements.
config lldp ports
{mac_phy_configuration_status | link aggregation | power_via_mdi |
maximum_frame_size}] [enable | disable]
Each Specific TLV in this extension can be enabled individually.
<portlist>  Specified a range of ports to be configured.
all  To set all ports in the system, you may use the "all" parameter.
mac_phy_configuration_status  This TLV optional data type indicates
that LLDP agent should transmit 'MAC/PHY configuration/status TLV'.
This type indicates it is possible for two ends of an IEEE 802.3 link to be
configured with different duplex and/or speed settings and still establish
some limited network connectivity. More precisely, the information
includes whether the port support the auto-negotiation function, whether
the function is enabled, the auto-negotiated advertised capability, and the
operational MAU type. The default state is disable.
link_aggregation  This TLV optional data type indicates that LLDP agent
should transmit 'Link Aggregation TLV'. This type indicates the current
link aggregation status of IEEE 802.3 MACs. More precisely, the
information should include whether the port is capable of doing link
aggregation, whether the port is aggregated in a aggregated link, and the
aggregated port ID. The default state is disable.
maximum_frame_size  This TLV optional data type indicates that LLDP
agent should transmit 'Maximum-frame-size TLV. The default state is
[<portlist>|all]
300
dot3_tlvs [all |