D-Link DES-3028 Cli Reference Manual page 59

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
Example usage:
To download a configuration file:
DES-3028P:4#download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DES-3028P:4#
DES-3028P:4##-------------------------------------------------------------------
DES-3028P:4##
DES-3028P:4##
DES-3028P:4##
DES-3028P:4##
DES-3028P:4##-------------------------------------------------------------------
DES-3028P:4#
DES-3028P:4#
DES-3028P:4## BASIC
DES-3028P:4#
DES-3028P:4#config serial_port baud_rate 9600 auto_logout 10_minutes
Command: config serial_port baud_rate 9600 auto_logout 10_minutes
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message "End of configuration file for DES-3028P" appears followed by the
command prompt.
DES-3028P:4#disable authen_policy
Command: disable authen_policy
Success.
DES-3028P:4#
config firmware
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-3028P Configuration
Firmware: Build 2.00.B23
Copyright(C) 2009 D-Link Corporation. All rights reserved.
Used to configure the firmware section image as a boot up section,
or to delete the firmware section
config firmware image_id <int 1-2> [delete | boot_up]
This command is used to configure the firmware section image. The
user may choose to remove the firmware section or use it as a boot
up section.
image_id – Specifies the working section image. The Switch can
hold two firmware versions for the user to select from, which are
specified by image ID.
delete – Entering this parameter will delete the specified firmware
section image.
boot_up – Entering this parameter will specify the firmware image ID
as a boot up section image.
Only Administrator-level users can issue this command.
54