D-Link DES-3028 Cli Reference Manual page 159

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
DES-3028P:4#
config 802.1x auth_parameter
Purpose
Syntax
Description
Parameters
Restrictions
Used to configure the 802.1X Authentication parameters on a range
of ports. The default parameter will return all ports in the specified
range to their default 802.1X settings.
config 802.1x auth_parameter ports [<auth_portlist> | all]
[default | {direction [both | in] | port_control [force_unauth |
auto | force_auth] | quiet_period <sec 0-65535> | tx_period <sec
1-65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-
65535> | max_req <value 1-10> | reauth_period <sec 1-65535> |
enable_reauth [enable | disable]}]
The config 802.1x auth_parameter command is used to configure
the 802.1X Authentication parameters on a range of ports. The
default parameter will return all ports in the specified range to their
default 802.1X settings.
<auth_portlist>  Specifies a port or range of ports to be configured.
all  Specifies all of the ports on the Switch.
default  Returns all of the ports in the specified range to their
802.1X default settings.
direction [both | in]  Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or
just the receiving direction.
port_control  Configures the administrative control over the
authentication process for the range of ports. The user has the
following authentication options:
force_auth  Forces the Authenticator for the port to

become authorized. Network access is allowed.


auto Allows the port's status to reflect the outcome of the
authentication process.
force_unauth  Forces the Authenticator for the port to

become unauthorized. Network access will be blocked.
quiet_period <sec 0-65535>  Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535>  Configures the time to wait for a
response from a supplicant (user) to send EAP Request/Identity
packets.
supp_timeout <sec 1-65535>  Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
Request/Identity packets.
server_timeout <sec 1-65535>  Configure the length of time to wait
for a response from a RADIUS server.
max_req <value 1-10>  Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 1-65535>  Configures the time interval between
successive re-authentications.
enable_reauth [enable | disable]  Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Only Administrator-level users can issue this command.
154