D-Link DES-3028 Cli Reference Manual page 161

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config 802.1x reauth
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1X reauthentication for ports 1-18:
DES-3028P:4#config 802.1x reauth port_based ports 1-
18
Command: config 802.1x reauth port_based ports 1-18
Success.
DES-3028P:4#
config radius add
Purpose
Syntax
Description
Parameters
DES-3028P:4# config 802.1x init port_based
ports all
Command: config 802.1x init port_based ports
all
Success.
DES-3028P:4#
Used to configure the 802.1X re-authentication feature of the Switch.
config 802.1x reauth {port_based ports [<auth_portlist> | all] |
mac_based | ports [<portlist> | all] {mac_address <macaddr>}]
The config 802.1x reauth command is used to re-authenticate a
previously authenticated device based on port number.
port_based – This instructs the Switch to re-authorize 802.1X functions
based only on the port number. Ports approved for re-authorization
can then be specified.
mac_based  This instructs the Switch to re-authorize 802.1X
functions based only on the port number or the MAC address. MAC
addresses approved for re-authorization can then be specified.
ports <auth_portlist>  Specifies a port or range of ports to be re-
authorized.
all  Specifies all of the ports on the Switch.
mac_address <macaddr>  Enter the MAC address to be re-
authorized.
Only Administrator-level users can issue this command.
Used to configure the settings the Switch will use to communicate with a
RADIUS server.
config radius add <server_index 1-3> <server_ip> key <passwd 32>
[default | {auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
The config radius add command is used to configure the settings the
Switch will use to communicate with a RADIUS server.
<server_index 1-3>  Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be entered
on the Switch.
156