D-Link DES-3028 Cli Reference Manual page 133

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
show ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display IP interface settings.
DES-3028P:4#show ipif
Command: show ipif
IP Interface Settings
Interface Name
IP Address
Subnet Mask
VLAN Name
Admin. State
Link Status
Member Ports
Total Entries : 1
DES-3028P:4#
enable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable auto configuration on the Switch:
Used to display the configuration of an IP interface on the Switch.
show ipif
This command will display the configuration of an IP interface on
the Switch.
None.
None.
: System
: 10.48.74.122
: 255.0.0.0
: default
: Disabled
: Link UP
: 1-28
Used to activate the auto configuration function for the Switch. This
will load a previously saved configuration file for current use.
enable autoconfig
When autoconfig is enabled on the Switch, the DHCP reply will
contain a configuration file and path name. It will then request the
file from the TFTP server specified in the reply. When autoconfig is
enabled, the ipif settings will automatically become DHCP client.
None.
When autoconfig is enabled, the Switch becomes a DHCP client
automatically (same as: config ipif System dhcp). The DHCP server
must have the TFTP server IP address and configuration file name,
and be configured to deliver this information in the data field of the
DHCP reply packet. The TFTP server must be running and have
the requested configuration file in its base directory when the
request is received from the Switch. Consult the DHCP server and
TFTP server software instructions for information on loading a boot
file or configuration file.
Only Administrator-level users can issue this command.
128
(MANUAL)