D-Link DES-3028 Cli Reference Manual page 322

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
Command
ports
config
dhcp_snoop
ports
Each command is listed, in detail, in the following sections.
create address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create address binding on the Switch:
DES-3028P:4#create
10.1.1.3 mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Success.
DES-3028P:4#
config address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Parameters
address_binding [<portlist> | all] limit [<value 1-10> | no_limit]
max_entry
Used to create an IP-MAC Binding entry.
create address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all]}
This command will create an IP-MAC Binding entry.
<ipaddr> – The IP address of the device where the IP-MAC binding is
made.
<macaddr> – The MAC address of the device where the IP-MAC
binding is made.
<portlist> – Specifies a port or range of ports to be configured for
address binding.
all – Specifies that all ports on the switch will be configured for address
binding.
Only Administrator-level users can issue this command.
address_binding
Used to configure an IP-MAC Binding entry.
config address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all]}
This command will configure an IP-MAC Binding entry.
<ipaddr> – The IP address of the device where the IP-MAC binding is
made.
<macaddr> – The MAC address of the device where the IP-MAC binding
is made.
<portlist> – Specifies a port or range of ports to be configured for address
binding.
all – Specifies that all ports on the switch will be configured for address
binding.
Only Administrator-level users can issue this command.
ip_mac
317
ipaddress