D-Link DES-3028 Cli Reference Manual page 301

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
Example usage
To change the notification interval:
DES-3028P:4# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DES-3028P:4#
config lldp ports notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To change the port SNMP notification state:
DES-3028P:4# config lldp ports 1-5 notification enable
Command: config lldp ports 1-5 notification enable
Success.
DES-3028P:4#
config lldp admin_status
Purpose
Syntax
Description
Parameters
Used to configure each port for sending notifications to configured SNMP
trap receiver(s).
config lldp ports [<portlist>|all] notification [enable | disable]
Enable or disable each port for sending change notifications to
configured SNMP trap receiver(s) if an LLDP data change is detected in
an advertisement received on the port from an LLDP neighbor. The
definition of change includes new available information, information
timeout and information update.
And the changed type includes any data update /insert/remove.
<portlist>  Specified a range of ports to be configured.
all  To set all ports in the system, you may use the "all" parameter.
notification  Enables or disables the SNMP trap notification of LLDP
data changes detected on advertisements received from neighbor
devices. The default notification state is disabled.
Only Administrator-level users can issue this command.
Used to configure per-port transmit and receive modes.
config lldp ports [<portlist>|all] admin_status [tx_only | rx_only |
tx_and_rx | disable]
These options enable the Switch to control which ports participate in
LLDP traffic and whether the participating ports allow LLDP traffic in only
one direction or in both directions.
<portlist>  Specified a range of ports to be configured.
all  To set all ports in the system, you may use the "all" parameter.
admin_status – To set the admin status.
tx_only: Configure the specified port(s) to transmit LLDP packets, but
block inbound LLDP packets from neighbor devices.
rx_only: Configure the specified port(s) to receive LLDP packets from
neighbors, but block outbound packets to neighbors.
tx_and_rx: Configure the specified port(s) to both transmit and receive
296