D-Link DES-3028 Cli Reference Manual page 236

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
Current Accounts:
UserName
-----------
Trinity
DES-3028P:4#
config ssh algorithm
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To configure SSH algorithm:
Authentication
------------------
Password
Note: To configure the SSH user, the administrator must create a user
account on the Switch. For information concerning configuring a user
account, please see the section of this manual entitled Basic Switch
Commands and then the command, create account.
Used to configure the SSH algorithm.
config ssh algorithm [3DES | AES128 | AES192 | AES256 | arcfour |
blowfish | cast128 | twofish128 | twofish192 | twofish256 | MD5 | SHA1 |
RSA | DSA] [enable | disable]
This command allows users to configure the desired type of SSH algorithm
used for authentication encryption.
3DES – This parameter will enable or disable the Triple_Data Encryption
Standard encryption algorithm.
AES128  This parameter will enable or disable the Advanced Encryption
Standard AES128 encryption algorithm.
AES192  This parameter will enable or disable the Advanced Encryption
Standard AES192 encryption algorithm.
AES256  This parameter will enable or disable the Advanced Encryption
Standard AES256 encryption algorithm.
arcfour  This parameter will enable or disable the Arcfour encryption
algorithm.
blowfish  This parameter will enable or disable the Blowfish encryption
algorithm.
cast128  This parameter will enable or disable the Cast128 encryption
algorithm.
twofish128  This parameter will enable or disable the twofish128 encryption
algorithm.
twofish192  This parameter will enable or disable the twofish192 encryption
algorithm.
MD5  This parameter will enable or disable the MD5 Message Digest
encryption algorithm.
SHA1  This parameter will enable or disable the Secure Hash Algorithm
encryption.
RSA  This parameter will enable or disable the RSA encryption algorithm.
DSA  This parameter will enable or disable the Digital Signature Algorithm
encryption.
[enable | disable] – This allows the user to enable or disable algorithms
entered in this command, on the Switch.
Only Administrator-level users can issue this command.
Host Name
----------------
231
Host IP
--------