D-Link DES-3028 Cli Reference Manual page 233

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config ssh authmode
Parameters
Restrictions
Example usage:
To enable the SSH authentication mode by password:
DES-3028P:4#config ssh authmode password enable
Command: config ssh authmode password enable
Success.
DES-3028P:4#
show ssh authmode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the current authentication mode set on the Switch:
DES-3028P:4#show ssh authmode
Command: show ssh authmode
The SSH authmode:
Password
Publickey
Hostbased
DES-3028P:4#
config ssh server
Purpose
Syntax
password – This parameter may be chosen if the administrator
wishes to use a locally configured password for authentication on the
Switch.
publickey  This parameter may be chosen if the administrator
wishes to use a publickey configuration set on a SSH server, for
authentication.
hostbased  This parameter may be chosen if the administrator
wishes to use a host computer for authentication. This parameter is
intended for Linux users requiring SSH authentication techniques
and the host computer is running the Linux operating system with a
SSH program previously installed.
[enable | disable]  This allows users to enable or disable SSH
authentication on the Switch.
Only Administrator-level users can issue this command.
Used to display the SSH authentication mode setting.
show ssh authmode
This command will allow users to display the current SSH
authentication set on the Switch.
None.
None.
: Enabled
: Enabled
: Enabled
Used to configure the SSH server.
config ssh server {maxsession <int 1-8> | timeout <sec 120-
600> | authfail <int 2-20> | rekey [10min | 30min | 60min | never]
228