D-Link DXS-1210-12TC Reference Manual page 324

40-3
This command is used to configure the polling interval of received packet counts. Use the no form of
this command to restore to its default settings.
storm-control polling {interval SECONDS | retries {NUMBER | infinite}}
no storm-control polling {interval | retries}
Parameters
interval SECONDS
retries NUMBER
Default
The default polling interval is 5 seconds.
The default retries count value is 3.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this to specify the sample interval of received packet counts.
Example
This example shows how to specify the polling interval as 15 seconds.
Switch# configure terminal
Switch(config)#storm-control polling interval 15
Switch(config)#
40-4
This command is used to display the current storm control settings.
show storm-control interface INTERFACE-ID [, | -] [broadcast | multicast | unicast]
Parameters
INTERFACE-ID
,
-
DXS-1210 Series Smart Managed Switch CLI Reference Guide
storm-control polling
Specifies the polling interval of received packet counts. This value
must be between 1 and 300 seconds.
Specifies the retry count. If the action is configured to the shutdown
mode and a storm continues as long as the interval times retries
values set, the port will enter the error disabled state. This value must
be between 0 and 360. 0 means that a shutdown mode port will
directly enter the error disabled state when a storm is detected. Infinite
means that a shutdown mode port will never enter the error disabled
state even if a storm was detected.
show storm-control
Specifies the port's interface ID.
(Optional)Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional)Specifies a range of interfaces. No space is allowed before
321