D-Link DXS-1210-12TC Reference Manual page 61

Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command enables or disables the Telnet server. The SSH access interface is separately
controlled by SSH commands.
Example
This example shows how to enable the Telnet server.
Switch# configure terminal
Switch(config)# ip telnet server
Switch(config)#
5-8 ip telnet service-port
This command is used to specify the service port for Telnet. Use the no form of this command to
revert to the default setting.
ip telnet service-port TCP-PORT
no ip telnet service-port
Parameters
TCP-PORT
Default
By default, this value is 23.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command configures the TCP port number for Telnet access
Example
This example shows how to change the Telnet service port number to 3000.
Switch# configure terminal
Switch(config)# ip telnet service-port 3000
Switch(config)#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the TCP port number. TCP ports are numbered between 1
and 65535.The "well-known" TCP port for the TELNET protocol is 23.
58