D-Link DXS-1210-12TC Reference Manual page 368

-
Default
The VLAN ID 1 exists in the system as the default VLAN.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the vlan global configuration command to create VLANs. Entering the vlan command with a
VLAN ID enters the VLAN configuration mode. Entering the VLAN ID of an existing VLAN does not
create a new VLAN, but allows the user to modify the VLAN parameters for the specified VLAN. When
the user enters the VLAN ID of a new VLAN, the VLAN will be automatically created.
Use the no vlan command to remove a VLAN. The default VLAN cannot be removed. If the removed
VLAN is a port's access VLAN, the port's access VLAN will be reset to VLAN 1.
Example
This example shows how to add new VLANs, assigning the new VLANs with the VLAN IDs 1000 to
1005.
Switch# configure terminal
Switch(config)#vlan 1000-1005
Switch(config-vlan)#
48-11
This command is used to specify the name of a VLAN. Use the no form of this command to reset the
VLAN name to the default VLAN name.
name VLAN-NAME
no name
Parameters
VLAN-NAME
Default
The default VLAN name is VLANx, where x represents four numeric digits (including the leading zeros)
that are equal to the VLAN ID.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the name of a VLAN. The VLAN name must be unique within the
administrative domain.
Example
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies a range of VLANs. No space is required before
and after the hyphen.
name
Specifies the VLAN name, with a maximum of 32 characters. The
VLAN name must be unique within the administrative domain.
365