D-Link DXS-1210-12TC Reference Manual page 372

Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# voice vlan enable
Switch(config-if)#
49-4 voice vlan mac-address
This command is used to add the user-defined voice device OUI. Use the no form of this command to
delete the user-defined voice device OUI.
voice vlan mac-address MAC-ADDRESS MASK [description TEXT]
no voice vlan mac-address MAC-ADDRESS MASK
Parameters
MAC-ADDRES
MASK
description TEXT
Default
The default OUI is listed in the following table:
OUI
00:E0:BB
00:03:6B
00:E0:75
00:D0:1E
00:01:E3
00:60:B9
00:0F:E2
00:09:6E
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add a user-defined OUI for the voice VLAN. The OUI for the voice VLAN is used
to identify the voice traffic by using the voice VLAN function. If the source MAC addresses of the
received packet matches any of the OUI patterns, the received packet is determined as a voice
packet.
The user-defined OUI cannot be the same as the default OUI. The default OUI cannot be deleted.
Example
This example shows how to add a user-defined OUI for voice devices.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the OUI MAC address.
Specifies the OUI MAC address matching bitmask.
(Optional) Specifies the description for the user defined OUI with a
maximum of 32 characters.
Vendor
3COM
Cisco
Veritel
Pingtel
Siemens
NEC/Philips
Huawei-3COM
Avaya
369