Ipv6 Mld Snooping Querier - D-Link DXS-1210-12TC Reference Manual

Parameters
interface
forbidden interface
INTERFACE-ID
Default
No IPv6 MLD snooping multicast router port is configured.
Auto-learning is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. To specify a multicast router port,
the valid interface can be a physical port or a port-channel. The specified multicast router port must be
member port of the configured VLAN.
The multicast router port can be either dynamically learned or statically configured into an MLD
snooping entity. With the dynamic learning, the MLD snooping entity will listen to MLD and PIMv6
packet to identify whether the partner device is a router.
Example
This example shows how to configure eth1/0/1 as an MLD snooping multicast router port and eth1/0/2
as an MLD snooping forbidden multicast router port on VLAN 1.
Switch# configure terminal
Switch(config)#vlan 1
Switch(config-vlan)# ipv6 mld snooping mrouter interface eth 1/0/1
Switch(config-vlan)# ipv6 mld snooping mrouter forbidden interface eth 1/0/2
Switch(config-vlan)#
28-6
This command is used to enable the MLD snooping querier on the Switch. Use the no form of this
command to disable the MLD snooping querier function.

ipv6 mld snooping querier

no ipv6 mld snooping querier
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies a range of interfaces as being connected to multicast-
enabled routers.
Specifies a range of interfaces as being not connected to multicast-
enabled routers.
Specifies an interface or an interface list. No space is allowed before
and after the comma. The interface can be a physical interface or a
port-channel.
ipv6 mld snooping querier
216