D-Link DXS-1210-12TC Reference Manual page 243

Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to enable or disable the acceptance of an authorized configuration. When
authorization is enabled for authentication, the authorized attributes (for example VLAN, 802.1p
default priority, bandwidth, and ACL) assigned by the RADIUS server will be accepted if the
authorization status is enabled. Bandwidth and ACL are assigned on a per-port basis. If in the multi-
auth mode, VLAN and 802.1p are assigned on a per-host basis. Otherwise, Bandwidth and ACL are
assigned on a per-port basis.
Example
This example shows how to enable the authorization status.
Switch# configure terminal
Switch(config)#no authorization disable
Switch(config)#
30-10
This command is used to display authentication information.
show authentication sessions [dot1x | interface INTERFACE-ID [, | -] [dot1x] | mac-address
MAC-ADDRESS]
Parameters
dot1x
interface INTERFACE-ID
,
-
mac-address MAC-ADDRESS
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
DXS-1210 Series Smart Managed Switch CLI Reference Guide
show authentication sessions
(Optional) Specifies to display all dot1x sessions.
(Optional) Specifies a port to display.
(Optional)Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional)Specifies a range of interfaces. No space is allowed before
and after the hyphen.
(Optional) Specifies to display a specific user.
240