D-Link DXS-1210-12TC Reference Manual page 44

Command Default Level
Level: 12.
Usage Guideline
This command is available in the MAC, IP, IPv6, and Expert Access-list Configure mode.
Example
This example shows how to add a remark to the access-list.
Switch# configure terminal
Switch(config)#ip access-list extended R&D
Switch(config-ip-ext-acl)# list-remark "This access-list is used to match any IP
packets from the host 10.2.2.1"
Switch(config-ip-ext-acl)# end
Switch# show access-list ip
Extended IP access list R&D(ID: 3999)
10 permit host 10.2.2.1 any
This access-list is used to match any IP packets from the host 10.2.2.1
Switch#
4-11
This command is used to specify a MAC accesslist to be applied to an interface. Use the no form of
this command to remove the access group control from the interface.
mac access-group {NAME | NUMBER} [in]
no mac access-group [NAME | NUMBER] [in]
Parameters
NAME
NUMBER
in
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If MAC access group is already configured on the interface, the command applied later will overwrite
the previous setting. MAC access-groups will only check non-IP packets.
Only one access list of the same type can be applied to the same interface; but access lists of
different types can be applied to the same interface.
The association of an access group with an interface will consume the filtering entry resource in the
switch controller. If the resource is insufficient to commit the command, then an error message will be
displayed.
Example
DXS-1210 Series Smart Managed Switch CLI Reference Guide
mac access-group
Specifies the name of the MAC accesslist to be applied.
Specifies the number of the MAC accesslist to be applied.
(Optional) Specifies that the MAC access list will be applied to check in
the ingress direction. If direction is not specified, in is used.
41