D-Link DXS-1210-12TC Reference Manual page 31

-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display the global configuration or interface configuration. If the
configuration command is entered without parameters, the global configuration will be
displayed.Otherwise, the configuration on the specified interface will be displayed.
Example
This example shows how to display the dot1X global configuration.
Switch# show dot1x
802.1X
Trap State
Switch#
This example shows how to display the dot1X configuration on Ethernet port 1/0/1.
Switch# show dot1x interface eth 1/0/1
Interface
PAE
Control Direction
Port Control
Tx Period
Supp Timeout
Server Timeout
Max-req
Forward PDU
Switch#
3-13
This command is used to display IEEE 802.1X diagnostics. If no interface is specified, information
about all interfaces will be displayed.
show dot1x diagnostics [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
DXS-1210 Series Smart Managed Switch CLI Reference Guide
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
show dot1x diagnostics
(Optional) Specifies to display the dot1x diagnostics on the specified
interface or range of interfaces. If not specified, information about all
interfaces will be displayed.
: Enabled
: Enabled
: eth1/0/1
: Authenticator
: Both
: Auto
: 30 sec
: 30 sec
: 30 sec
: 2 times
: Disabled
28