Show Errdisable Recovery - D-Link DXS-1210-12TC Reference Manual

Switch# configure terminal
Switch(config)#errdisable recovery cause psecure-violation interval 200
Switch(config)#
This example shows how to enable the auto-recovery option for port security violations.
Switch# configure terminal
Switch(config)#errdisable recovery cause psecurity-violation
Switch(config)#
17-2

show errdisable recovery

This command is used to display the error-disable recovery timer related settings.
show errdisable recovery
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to verify the settings of the error disable recovery timer.
Example
This example shows how to display the settings of the error disable recovery timer.
Switch(config)#show errdisable recovery
ErrDisable Cause
----------------------
Port Security
Storm Control
ARP Rate
BPDU Attack Protection
DHCP Rate
Loopback Detect
Interfaces that will be recovered at the next timeout:
Interface
----------
eth1/0/1
eth1/0/2
Switch#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
State
----------
disabled
disabled
disabled
disabled
disabled
enabled
vlan ErrDisable Cause
------ ----------------------
- Loopback Detect
- Loopback Detect
Interval
------------
120 seconds
120 seconds
120 seconds
120 seconds
120 seconds
120 seconds
Time left
------------
105 seconds
105 seconds
122