D-Link DXS-1210-12TC Reference Manual page 212

Switch# show snmp-server traps loopback-detection
Loopback Detection Trap State: disable
Switch#
26-8
This command is used to set the loop action of loopback detection. Use the no form of this command
to revert to the default setting.
loopback-detection action {shutdown | none}
no loopback-detection action
Parameters
shutdown
none
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the loop action.
Example
This example shows how to set the loop action of loopback detection.
Switch(config)# loopback-detection action shutdown
Switch(config)#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
loopback-detection action
Loop action to shutdown port
Loop action none
209