Surveillance Vlan Commands - D-Link DXS-1210-12TC Reference Manual

Dxs-1210 series l2 10 gigabit ethernet switch
Hide thumbs Also See for DXS-1210-12TC:
Table of Contents

Advertisement

41. Surveillance VLAN Commands

41-1
This command is used toenable the global surveillance VLAN state and configure the surveillance
VLAN. Use the no form of this command to disable the surveillance VLAN state.
surveillance vlan VLAN-ID
no surveillance vlan
Parameters
VLAN-ID
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable the global surveillance VLAN function and to specify the surveillance
VLAN on the Switch. Each switch can only have one Surveillance VLAN.
Both the surveillance vlan command in Global Configuration Mode and the surveillance vlan
enable command in Interface Configuration Mode need to be enabled for a port to start the
surveillance VLAN function.
When the surveillance VLAN is enabled for a port, the port will be automatically learned as
surveillance VLAN untagged member, the received untagged surveillance packets will be forwarded
to the surveillance VLAN. The received packets are determined as surveillance packets if the source
MAC addresses of packets comply with the organizationally unique identifier (OUI) addresses
configured by the surveillance vlan mac-address command.
A VLAN needs to be created before assigning the VLAN as the surveillance VLAN.
If the surveillance VLAN is configured, this VLAN cannot be removed using the no vlan command.
Example
This example shows how to enable the surveillance VLAN function and configure VLAN 1001 as a
Surveillance VLAN.
Switch# configure terminal
Switch(config)# surveillance vlan 1001
Switch(config)#
41-2
This command is used to configure the aging time for aging out the surveillance VLAN dynamic
member ports. Use the no form of this command to reset the aging time to the default setting.
surveillance vlan aging MINUTES
no surveillance vlan aging
DXS-1210 Series Smart Managed Switch CLI Reference Guide
surveillance vlan
Specifies the ID of the surveillance VLAN. The range is from 2 to 4094.
surveillance vlan aging
324

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxs-1210-12scDxs-1210-10tsDxs-1210-16tc

Table of Contents