D-Link DXS-1210-12TC Reference Manual page 112

Switch# show ip dhcp server-screen log
Total log buffer size: 64
VLAN Server IP
------ --------------- ----------------- ----------------------
100 10.20.1.1
100 10.58.2.30
Total Entries: 2
Switch#
13-8 snmp-server enable traps dhcp-server-screen
This command is used to enable sending SNMP notifications for the forge DHCP Server attacking.
Use the no form of this command to disable sending SNMP notifications.
snmp-server enable traps dhcp-server-screen
no snmp-server enable traps dhcp-server-screen
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When DHCP Server Screen is enabled and the Switch receives the forge DHCP Server packet, the
Switch will log the event if any attacking packet is received. You can use this command to enable or
disable the sending of the SNMP notifications for such events.
Example
This example shows how start sending traps for DHCP Server Screen.
Switch# configure terminal
Switch(config)# snmp-server enable traps dhcp-server-screen
Switch(config)#
13-9 show dhcp-server-screen profile
This command is used to display information about the DHCP server screening profile settings.
show dhcp-server-screen profile
Parameters
None.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Client MAC
00-20-30-40-50-60 06:30:37, 2014-03-10
10-22-33-44-50-60 06:31:42, 2014-03-10
Occurrence
109