D-Link DXS-1210-12TC Reference Manual page 256

By default, all the options are disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The user can enable or disable dimming LEDs, port shutdown, and hibernation using this command.
When dim LED is enabled, the device will turn off all the port's LEDs in the specified time range to
save power.
When port shutdown is enabled, the device will shut off all ports in the specified time range to save
power.
When hibernation is enabled, the device will enter the hibernation mode in the specified time range to
save power. This parameter can only be used when the stacking is disabled.
Example
This example shows how to enable power saving by shutting off the Switch's ports and toggle the
Switch into the hibernation mode.
Switch# configure terminal
Switch(config)#power-saving port-shutdown
Switch(config)# power-saving hibernation
Switch(config)#
32-3 power-saving eee
This command is used to enable the Energy-Efficient Ethernet (EEE) function on the specified port(s).
Use the no form of this command to disable the EEE function.
power-saving eee
no power-saving eee
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable or disable the specified port's EEE power saving function. The Energy-
Efficient Ethernet (EEE) power-saving mode saves power consumption while a link is up when there
is low utilization of packet traffic. The physical interface will enter into a Low Power Idle (LPI) mode
when there is no data to be transmitted. In the EEE power-saving mode, power consumption is
scalable to the actual bandwidth utilization.
Example
This example shows how to enable the EEE power saving function.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
253