Show Ipv6 Neighbors - D-Link DXS-1210-12TC Reference Manual

Use this command to display IPv6 interface related configurations.
Example
This example shows how to display IPv6 interface information.
Switch# show ipv6 interface vlan 2
vlan2 is up, Link status is down
IPv6 is enabled,
link-local address:
Global unicast address:
RA advertised retransmit interval is 0 milliseconds
Switch#
This example shows how to display brief IPv6 interface information.
Switch# show ipv6 interface brief
vlan1 is up, Link status is up
FE80::201:1FF:FE02:304
vlan2 is up, Link status is down
FE80::201:1FF:FE02:305
200::2
vlan3 is up, Link status is down
FE80::201:1FF:FE02:306
Total Entries: 3
Switch#

9-7 show ipv6 neighbors

This command is used to display IPv6 neighbor information.
show ipv6 neighbors [INTERFACE-ID] [IPV6-ADDRESS]
Parameters
IPV6-ADDRESS
INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
DXS-1210 Series Smart Managed Switch CLI Reference Guide
FE80::201:1FF:FE02:305
200::2/64 (DHCPv6 PD)
Specifies the IPv6 address to display its IPv6 neighbor cache entry.
Specifies the interface to display IPv6 neighbor cache entry.
91