D-Link DXS-1210-12TC Reference Manual page 314

Parameters
hello-time SECONDS
forward-time SECONDS
max-age SECONDS
Default
The default value of the hello-time is 2 seconds.
The default value of the forward-time is 15 seconds.
The default value of the max-age is 20 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the SpanningTree timer value.
Example
This example shows how to configure the STP timers.
Switch# configure terminal
Switch(config)#spanning-tree hello-time 1
Switch(config)# spanning-tree forward-time 16
Switch(config)# spanning-tree max-age 21
Switch(config)#
39-7
This command is used to enable or disable the STP operation. Use the no form of this command to
revert to the default setting.
spanning-tree state {enable | disable}
no spanning-tree state
Parameters
enable
disable
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the interval that a designated port will wait between the
periodic transmissionsof each configuration message. The range is
from 1 to 2 seconds.
Specifies the forward delay time used by STP to transition from the
listening to the learning states and learning to forwarding states. The
range is from 4 to 30 seconds.
Specifies the maximum message age of BPDU. The range is from 6 to
40 seconds.
spanning-tree state
Specifies to enable STP for the configured interface.
Specifies to disable STP for the configured interface.
311