Show Dot1X - D-Link DXS-1210-12TC Reference Manual

dot1x timeout {server-timeout SECONDS | supp-timeout SECONDS | tx-period SECONDS}
no dot1x timeout {server-timeout | supp-timeout | tx-period}
Parameters
server-timeout SECONDS
supp-timeout SECONDS
tx-period SECONDS
Default
The server-timeout is 30 seconds.
The supp-timeout is 30 seconds.
The tx-period is 30 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for physical port interface configuration.
Example
This example shows how to configure the servertimeout value, supplicant timeout value, and the TX
period on Ethernet port 1/0/1 to be15, 15, and 10 seconds, respectively.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# dot1x timeout server-timeout 15
Switch(config-if)# dot1x timeout supp-timeout 15
Switch(config-if)# dot1x timeout tx-period 10
Switch(config-if)#
3-12
This command is used to display the IEEE 802.1X global configuration or interface configuration.
show dot1x [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
,
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the number of seconds that the Switch will wait for the
request from the authentication server before timing out the server. On
timeout, authenticator will send EAP-Request packet to client. The
range is 1 to 65535.
Specifies the number of seconds that the Switch will wait for the
response from the supplicant before timing out the supplicant
messages other than EAP request ID. The range is 1 to 65535
Specifies the number of seconds that the Switchwill wait for a
response to an EAP-Request/Identity frame from the supplicant before
retransmitting the request. The range is 1 to 65535

show dot1x

(Optional) Specifies to display the dot1x configuration on the specified
interface or range of interfaces. If not specified, the global
configuration will be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
27