Right And Left Tail Lamp Bulb M2 / M4 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

4.5.2 Tail Lamp, Removing and Installing,
Wagon
The removal and installation is described for the left side. Re‐
moving and installing on the right side is identical.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Open the cover in the luggage compartment side trim panel.
– Disconnect the connector.
– Remove the fastening element -1-.
– Remove the tail lamp -2- in the direction of the -arrow A-.
Installing
Install in the reverse order of removal while paying attention to
the following:
– Perform a function test.
Tightening Specifications
♦ Refer to
⇒ "4.1.3 Overview - Body Tail Lamps, Wagon", page 136
4.6 Right and Left Tail Lamp Bulb - M2- / -
M4- , Removing and Installing
⇒ "4.6.1 Right and Left Tail Lamp Bulb M2 / M4 , Removing and
Installing, Sedan", page 145
⇒ "4.6.2 Right and Left Tail Lamp Bulb M2 / M4 , Removing and
Installing, Wagon", page 146
4.6.1 Right and Left Tail Lamp Bulb - M2- / -
M4- , Removing and Installing, Sedan
The removal and installation is described for the left side. Re‐
moving and installing on the right side is identical.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
Caution
Risk of damaging the component surfaces.
♦ When positioning a prying tool, put commercially available
adhesive tape over the component in the visible area.
– If necessity insert a narrow screwdriver in the opening on the
side.
Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
145
4. Tail Lamps