Windshield Wiper Motor, Replacing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– When necessary disconnect the damping regulation connec‐
tor.
– Remove the wiper frame -2- with linkage and the Windshield
Wiper Motor - V- from the plenum chamber.
Installing
Install in the reverse order of removal while paying attention to
the following:
– Adjust the windshield wiper arms. Refer to
⇒ "1.5 Windshield Wiper Arms, Adjusting", page 58
Tightening Specifications
♦ Refer to
⇒ Fig. ""Tightening Specifications and Sequence for the Wind‐
shield Wiper Motor -V- "" , page 55
1.7

Windshield Wiper Motor, Replacing

Special tools and workshop equipment required
♦ Pry Lever - 80-200-
♦ Torque Wrench 1410 - VAG1410-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
WARNING
Risk of injury.
♦ When operating an uncovered windshield wiper system
there is a risk of pinching.
♦ The windshield wiper system can only be operated when
installed.
Caution
There is a risk of damaging the hood and the windshield wiper
arm.
♦ By operating the windshield wiper system with the hood
open, pay attention that the is enough clearance to moving
components.
So that the windshield wiper system can be operated with the front
lid open, the latch must be engaged in the »closed« position.
Removing
– Deactivate the wiper motor alternating park position. Refer to
⇒ "1.8 Windshield Wiper Motor, Deactivating Alternating Park
Position Function", page 61
– Remove the windshield wiper frame. Refer to
⇒ "1.6 Windshield Wiper Motor V , Removing and Installing",
page 59 .
60
Rep. Gr.92 - Wiper/Washer Systems
.
.