Volkswagen Golf 2015 Repair Manual page 34

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
-B- large decoupling belt pulley with freewheel, special tool to be
used -3400-
Note
The ribbed belt for the large decoupling belt pulley with freewheel
must be longer, because the decoupling belt pulley with freewheel
has a larger diameter and it is different for vehicles with and with‐
out an A/C system.
Removing
– Remove the Generator - C- . Refer to
⇒ "2.2 Generator, Removing and Installing", page 15
– Secure the Generator - C- in a vise by the mounting points.
– If equipped, remove the protective cap from the decoupling
belt pulley with freewheel.
– Install the -T10474- or -3400- -1- in the belt pulley and attach
a wrench (SW 17).
– Install the -VAG1603A/1- -2- in the generator shaft.
– Turn the generator shaft clockwise to loosen and while doing
so counterhold with the wrench.
– Hold the decoupling belt pulley with freewheel in place by hand
and turn it at the generator shaft until the decoupling belt pulley
with freewheel can be removed.
Installing
Install in reverse order of removal. Note the following:
The -VAG1332- must be rearranged for installing the decoupling
belt pulley with freewheel as follows:
– Release the insert -1- and remove it from the handle part -2-.
– Turn the handle part -2- of the torque wrench 180° and reinsert
the socket.
– Set the rotation direction of the torque wrench socket to "left".
– Next, screw the ribbed belt pulley with freewheel by hand onto
the generator shaft until stop.
26
Rep. Gr.27 - Battery, Starter, Generator, Cruise Control
.