Left/Right Hid Headlamp Control Module J343 / J344 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Turn the housing cover -1- in the direction of the -arrow A- and
remove from the headlamp.
– Push upward in the direction of the -arrow A- on the bulb sock‐
et -1-.
– Remove the bulb socket -1- from the reflector -2-.
– Disconnect the connector.
Installing
Install in the reverse order of removal while paying attention to
the following:
Caution
There is a risk of damaging the headlamp.
♦ Do not touch glass cone of bulb with bare fingers. Fingers
will leave traces of grease on the glass which, when the
bulb is switched on, will evaporate and cloud the glass.
♦ Use clean cloth gloves to insert the bulbs.
♦ During installation, ensure proper seating of the housing
cover. Water getting in the headlamp will cause damage.
– Perform a function test.
– Check and correct headlamp adjustment, if necessary. Refer
to ⇒ Maintenance ; Booklet 36.1 ; Procedure Descriptions .
1.17 Left/Right HID Headlamp Control Mod‐
ule - J343- / -J344- , Removing and In‐
stalling
The removal and installation is described for the left side. Re‐
moving and installing on the right side is identical.
WARNING
High voltage poses a life-endangering risk, injury risk and en‐
vironmental hazard.
♦ Pay attention to usage and safety information for HID
headlamps. Refer to
⇒ "1.3 HID Headlamps Usage and Safety Precautions",
page 2 .
♦ It is necessary to disconnect the battery wire strap before
working on HID headlamp components. These parts are
marked with yellow high voltage symbols.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
120
Rep. Gr.94 - Exterior Lights, Switches