Overview - Data Bus On Board Diagnostic Interface; Vehicle Electrical System Control Module J519 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

2.3

Overview - Data Bus On Board Diagnostic Interface

1 - Connector
❑ For Data Bus On Board
Diagnostic Interface -
J533-
2 - Data Bus On Board Diag‐
nostic Interface - J533-
❑ Removing and instal‐
ling. Refer to
⇒ "2.5 Data Bus On
Board Diagnostic Inter‐
face J533 , Removing
and Installing",
page 300 .
3 - Bolt
❑ Tightening specifica‐
tion. Refer to ⇒ Body
Interior; Rep. Gr. 70 ;
Instrument Panel Cen‐
tral Tube; Overview - In‐
strument Panel Central
Tube .
4 - Crash Bracket
❑ Overview. Refer to ⇒
Body Interior; Rep. Gr.
70 ; Instrument Panel
Central Tube; Overview
- Instrument Panel Cen‐
tral Tube .
5 - Instrument Panel Central
Tube
2.4 Vehicle Electrical System Control Mod‐
ule - J519- , Removing and Installing
If the control module is being replaced, use the Vehicle Diagnostic
Tester and select the "Replacing" function for the respective con‐
trol module in "Guided Fault Finding".
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the A-pillar lower trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Passenger Compartment Trim; A-Pillar Trim
Panel, Removing and Installing .
– Remove the footwell cover on the driver side. Refer to ⇒ Body
Interior; Rep. Gr. 68 ; Storage Compartments and Covers;
Driver Side Footwell Cover, Removing and Installing .
Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
299
2. Control Modules