Battery Tray, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Loosen the nut -3- several turns and remove the battery
ground cable terminal clamp -2- from the battery terminal.
Connecting
Pay attention to the following when disconnecting the Battery -
A- .
– Release and disconnect the connector -2- from the Battery
Monitoring Control Module - J367- -3-.
– Install the battery ground cable terminal clamp by hand on the
battery negative terminal "–".
– Tighten the nut -1- to the tightening specification.
– Reconnect the connector -2- to the Battery Monitoring Control
Module - J367- .
– Turn on the ignition.
– Check the time and if necessary adjust.
– Window, open and close all the way.
– Then, with the windows closed, pull the power window switch
until the relay audibly switches.
– Check the window regulator convenience switch.
While comfort switching is operated, window must close without
holding the power window switch.
Note
After connecting the power supply, the ASR/ESP Indicator Lamp
- K155- may only go out after the vehicle has been driven a few
yards.
Tightening Specifications
♦ Refer to ⇒ "1.1 Overview - Battery", page 6
1.4

Battery Tray, Removing and Installing

Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
– If necessary, remove the air filter housing. Refer to ⇒ Rep.
Gr. 23 ; Air Filter; Air Filter Housing, Removing and Installing
or ⇒ Rep. Gr. 24 ; Air Filter; Air Filter Housing, Removing and
Installing .
– Remove the Battery - A- . Refer to
⇒ "1.2 Battery, Removing and Installing", page 7
10
Rep. Gr.27 - Battery, Starter, Generator, Cruise Control
.