Blind Spot Detection, Calibrating - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Remove the bolt -3-.
– Remove the Blind Spot Detection Control Module - J1086- /
Blind Spot Detection Control Module 2 - J1087- -2- from the
bracket -1-.
Installing
Install in the reverse order of removal while paying attention to
the following:
Note
The blind spot detection calibration normally occurs automat‐
♦
ically.
Static calibration is only required when there is a DTC memory
♦
entry.
Tightening Specifications
♦ Refer to ⇒ "13.1 Overview - Blind Spot Detection", page 217
13.4

Blind Spot Detection, Calibrating

⇒ "13.4.1 Preparing for Calibration", page 222
13.4.1 Preparing for Calibration
Note
The vehicle in the illustration is only a basic outline.
222
Rep. Gr.94 - Exterior Lights, Switches