Steering Lock Housing, Removing And Installing - Volkswagen Golf 2015 Repair Manual

– Position the steering wheel as far back as possible. Use the
entire adjustment range of the steering column adjustment for
this.
– Remove the lower steering column trim panel. Refer to ⇒ Body
Interior; Rep. Gr. 68 ; Storage Compartments and Covers;
Lower Steering Column Trim Panel, Removing and Installing .
– Remove the Anti-Theft Immobilizer Reader Coil - D2- -2- in the
direction of the -arrow A- from the mount -1-.
Installing
Install in the reverse order of removal while paying attention to
the following:
– Push in the Anti-Theft Immobilizer Reader Coil - D2- until it
engages audibly in the mount.
8.11 Steering Lock Housing, Removing and
Installing
Special tools and workshop equipment required
♦ 7/16 Inch Extractor - T10424US-
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the steering column switch module. Refer to
⇒ "8.5 Steering Column Switch Module, Removing and Instal‐
ling", page 182 .
– Disconnect the connectors -1 and 4-.
If the shear bolt cannot be removed using the -T10424US- , use
an angled hand drill and 8.5 mm diameter bit to drill it out.
– Remove the shear bolt -2- using the -T10424US- .
– Remove the steering lock housing -3-.
To replace the steering lock housing, the Ignition/Starter Switch -
D- and lock cylinder must be removed.
– Remove the Ignition/Starter Switch - D- . Refer to
⇒ "8.4 Ignition/Starter Switch, Removing and Installing", page
181 .
– Remove lock cylinder. Refer to
⇒ "8.2 Lock Cylinder, Removing and Installing", page 179
Installing
Install in the reverse order of removal while paying attention to
the following:
Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
.
8. Steering Column Switch Module
195