Volkswagen Golf 2015 Repair Manual page 234

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Secure the Calibration Tool - Lane Change Calibration Tool -
VAS6350/4- to the Calibration Unit - VAS6350A- mount on the
rear left side.
• When installed correctly, the vehicle electrical system voltage
line must be connected at bottom left of calibration device (as
seen in direction of travel).
• Sedan dimension -a- = 606 mm (measured from the upper
edge of the calibration device to workshop floor).
• Wagon dimension -a- = 618 mm (measured from the upper
edge of the calibration device to workshop floor).
– The adjustment dimension is set with the measuring point
-arrow- on the base of the calibration device on the scale of
the steel ruler -1-.
• Left adjustment dimension for Sedan = 621 mm (read on
measuring scale -1-).
• Left adjustment dimension for Wagon = 678 mm (read on
measuring scale -1-).
– Connect the Calibration Tool - Lane Change Calibration Tool
Calibration Tool - Lane Change Calibration Tool - VAS6350/4-
to the vehicle electrical system voltage.
– Using the bubble level (level indicator) -arrow-, bring the Cal‐
ibration Unit - VAS6350A- into a horizontal position by turning
the plastic bases.
– Wear laser protective eyewear.
Note
The vehicle in the illustration is only a basic outline.
– Turn on the Calibration Laser - VAS6350/3A- on the Calibra‐
tion Unit - VAS6350A- .
– Align the entire Calibration Unit - VAS6350A- so that the laser
beam shines on the center of the vehicle rear above the VW
logo.
226
Rep. Gr.94 - Exterior Lights, Switches