Volkswagen Golf 2015 Repair Manual page 232

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
10 - Catch Bracket
❑ To mount the Calibration Tool - Spacing Laser - VAS6350/2- for the distance measurement
❑ Distance to the Calibration Tool - Wheel Center Mountings - VAS6350/1- on the rear wheels: dimension
-a- = 1700 ± 2 mm
13.4.2 Calibration Preparation Work
Special tools and workshop equipment required
♦ Calibration Unit - VAS6350A-
♦ Calibration Tool - Wheel Center Mountings - VAS6350/1-
♦ Calibration Tool - Spacing Laser - VAS6350/2-
♦ Calibration Tool - Lane Change Calibration Tool - VAS6350/4-
♦ Vehicle Diagnostic Tester
Various preparation work procedures must be performed before
the actual calibration procedure using the Vehicle Diagnostic
Tester .
Requirements
• Move the vehicle onto a secure flat surface.
• Apply the parking brake - the vehicle must not move during the
measurement.
• Place the front wheels in a straight-ahead position - steering
wheel neutral position.
• No persons may be in the vehicle interior during the meas‐
urement.
• Do not open and close the vehicle doors during calibration.
Procedure
– Connect the Vehicle Diagnostic Tester .
– Turn on the ignition.
– Tighten three wheel bolt adapters (17 mm) for the wheel bolts
on each -VAS6350/1- .
– Insert the measuring paddle on both -VAS6350/1- and secure
it with the locking nut.
– Place the -VAS6350/1- onto the wheel bolts on both rear
wheels.
• The wheel center sensor rotation center must be in wheel ro‐
tation center.
Note
Place the -VAS6350/1- on the wheels so that the "anti-theft wheel
bolts" are not connected with wheel center mounting.
– Adjust the measuring paddle using the lock nuts so that they
move freely just above the floor.
• The measuring paddles must move easily.
• The measuring paddles must be vertical.
224
Rep. Gr.94 - Exterior Lights, Switches