Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Release and disconnect the connectors -1, 2, and 3-.
– To disconnect the connector press the circlip -1-.
– Pivot the retaining bracket in direction of -arrow- and remove
the connector.
– Release the springs -arrow-, pivot the Vehicle Electrical Sys‐
tem Control Module - J519- -4- out of the bracket -5- and
remove downward.
Installing
Install in reverse order of removal.
2.5
Data Bus On Board Diagnostic Interface
- J533- , Removing and Installing
If the control module is being replaced, use the Vehicle Diagnostic
Tester and select the "Replacing" function for the respective con‐
trol module in "Guided Fault Finding".
300
Rep. Gr.97 - Wiring