Rear Lid Tail Lamp, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
4.3 Rear Lid Tail Lamp, Removing and In‐
stalling
⇒ "4.3.1 Rear Lid Tail Lamp, Removing and Installing, Sedan",
page 140
⇒ "4.3.2 Rear Lid Tail Lamp, Removing and Installing, Wagon",
page 141
4.3.1 Rear Lid Tail Lamp, Removing and In‐
stalling, Sedan
The removal and installation is described for the left side. Re‐
moving and installing on the right side is identical.
IF the LED is faulty, the tail lamp must be completely replaced.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
Caution
Risk of damaging the component surfaces.
♦ When positioning a prying tool, put commercially available
adhesive tape over the component in the visible area.
– If necessity insert a narrow screwdriver in the opening on the
side.
– Pry up the cover -1- in the direction of -arrow-.
– Release and disconnect the connector -2-.
– Remove the nuts -1-.
140
Rep. Gr.94 - Exterior Lights, Switches