Volkswagen Golf 2015 Repair Manual page 24

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Remove the Generator - C- -1- downward and to the right.
Installing
Install in the reverse order of removal while paying attention to
the following:
– Move the bolt sleeves slightly to the rear to make it easier to
install the Generator - C- .
Tight bushings for generator mount must be made smooth-run‐
ning, otherwise clamping force of bushing is too little despite
correct torque.
– Connect the Battery - A- . Refer to
⇒ "1.3 Battery, Disconnecting and Connecting", page 9
– After completing work always start the engine and check the
belt routing.
Tightening Specifications
♦ Refer to
⇒ "2.1.2 Overview - Generator with Bushings", page 14
2.2.2 Generator, Removing and Installing, Ve‐
hicles with 2.0L TSI Engine
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Engine Bung Set - VAS6122-
Removing
– Disconnect the Battery - A- . Refer to
⇒ "1.3 Battery, Disconnecting and Connecting", page 9
– Remove fan shroud. Refer to ⇒ Rep. Gr. 19 ; Radiator/Cool‐
ant Fan; Fan Shroud, Removing and Installing .
– Remove the ribbed belt. Refer to ⇒ Rep. Gr. 13 ; Cylinder
Block, Belt Pulley Side; Ribbed Belt, Removing and Installing .
– Remove the bolts -1 and 2-.
16
Rep. Gr.27 - Battery, Starter, Generator, Cruise Control
.
.