Volkswagen Golf 2015 Repair Manual page 120

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Pull the Left Headlamp Beam Adjustment Motor - V48- -1- in
the direction of the -arrow C-.
– Turn the height adjustment -2- in the direction of the
-arrow B- (lower the reflector). While doing so hold the Left
Headlamp Beam Adjustment Motor - V48- -1- tensioned.
– Remove the Left Headlamp Beam Adjustment Motor - V48-
-1- from the headlamp height adjustment in the direction of the
-arrow C-.
– Disengage the connector and disconnect.
Installing
Install in the reverse order of removal while paying attention to
the following:
Caution
There is a risk of damaging the headlamp.
♦ During installation, ensure proper seating of the housing
cover. Water getting in the headlamp will cause damage.
– Connect the connector when pushing in the Left Headlamp
Beam Adjustment Motor - V48- .
– Pull the reflector rearward and push the Left Headlamp Beam
Adjustment Motor - V48- in the headlamp-height adjustment,
until it engages audibly.
– Secure the Left Headlamp Beam Adjustment Motor - V48-
-1- in the direction of the arrow -A-.
– Turn the height adjustment -2- opposite of the direction of the
arrow -B-. The reflector must be moveable.
– Perform a function test.
– Check and correct headlamp adjustment, if necessary. Refer
to ⇒ Maintenance ; Booklet 36.1 ; Procedure Descriptions .
1.8.2 Left/Right Headlamp Beam Adjustment
Motor - V48- / -V49- , Removing and In‐
stalling, HID Headlamps
The removal and installation is described for the left side. Re‐
moving and installing on the right side is identical.
Removing
– Remove the headlamp. Refer to
⇒ "1.2 Headlamp, Removing and Installing", page 101
112
Rep. Gr.94 - Exterior Lights, Switches
.