Volkswagen Golf 2015 Repair Manual page 27

– Remove the bolts -arrows-.
– Move aside the coolant pipe -1-.
– Remove the bolts -1 and 2-.
– Pivot the Generator - C- -3- in the direction of travel.
– Release and disconnect the connector -1-.
– Pry off the cap -2- and remove the underlying nuts.
– Remove the terminal 30/B+ -3-.
– Remove the Generator - C- -4- upward from the vehicle.
Installing
Install in the reverse order of removal while paying attention to
the following:
– Connect the Battery - A- . Refer to
⇒ "1.3 Battery, Disconnecting and Connecting", page 9
Tightening Specifications
♦ Refer to
⇒ "2.1.1 Overview - Generator without Bushings", page 13
2.2.4 Generator, Removing and Installing, Ve‐
hicles with 1.6L MPI Engine
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
– Disconnect the Battery - A- . Refer to
⇒ "1.3 Battery, Disconnecting and Connecting", page 9
– Remove the ribbed belt. Refer to ⇒ Rep. Gr. 13 ; Cylinder
Block, Belt Pulley Side; Ribbed Belt, Removing and Installing .
– Remove the ribbed belt tensioner. Refer to ⇒ Rep. Gr. 13 ;
Cylinder Block, Belt Pulley Side; Ribbed Belt Tensioner, Re‐
moving and Installing .
Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
.
.
19
2. Generator