Left/Right Daytime Running Lamp And Position Lamp Control Module J860 / J861 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Press the release button -4-.
– Disconnect the connector -3-.
Installing
Install in the reverse order of removal while paying attention to
the following:
Caution
Make sure the seal fits correctly when installing the HID head‐
lamp control module. Water getting in the headlamp will cause
damage.
– Make sure the seal between the control module and the head‐
lamp is not damaged.
Tightening Specifications
♦ Refer to ⇒ "1.1 Overview - Headlamp", page 92
1.19 Left/Right Daytime Running Lamp and
Position Lamp Control Module - J860- /
-J861- , Removing and Installing
The removal and installation is described for the left side. Re‐
moving and installing on the right side is identical.
The Left Daytime Running Lamp and Position Lamp Control Mod‐
ule - J860- / Right Daytime Running Lamp and Position Lamp
Control Module - J861- is only installed with HID headlamps.
WARNING
High voltage poses a life-endangering risk, injury risk and en‐
vironmental hazard.
♦ Pay attention to usage and safety information for HID
headlamps. Refer to
⇒ "1.3 HID Headlamps Usage and Safety Precautions",
page 2 .
♦ It is necessary to disconnect the battery wire strap before
working on HID headlamp components. These parts are
marked with yellow high voltage symbols.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the headlamp. Refer to
⇒ "1.2 Headlamp, Removing and Installing", page 101
– Remove the screws -2-.
– Remove the Left Daytime Running Lamp and Position Lamp
Control Module - J860- -1- from the headlamp.
– Disconnect the connector -3-.
122
Rep. Gr.94 - Exterior Lights, Switches
.