Table of Contents
Advertisement
Configure Enclosure Bay IP Addressing
e On the SNMP Settings page, click Skip.
4 Configure the power and finish the wizard:
a On the Power Management page, select AC Redundant and click Next.
b On the Finish page, ensure that Do not automatically show this wizard again is checked, and click
Finish.
Configure Enclosure Bay IP Addressing
After the Enclosure wizard is finished, the next task is to configure the enclosure bay IP addressing (EBIPA)
so that the blade iLOs and the enclosure interconnects can obtain IP addresses.
Procedure
1 From the left side of the UI, select Enclosure Information > Enclosure Bay IP Addressing > IPv4.
2 On the Device tab for bay 1, enter the IP address, subnet mask, gateway, domain, and DNS servers in
the appropriate fields of the configuration worksheet.
3 Choose the appropriate option for populating the EBIPA information in the rest of the blades:
•
If the IP information is contiguous for all blades in the enclosure, click Autofill.
•
If it is not contiguous, enter the information for each blade manually based on the configuration sheet.
©
Copyright
2017 by Nimble Storage, Inc. All rights reserved.
Documentation Feedback
43
Advertisement
Table of Contents
