Configure Global Fcoe Parameters - HP Converged Architecture 700 Deployment Manual

Configure Global FCoE Parameters

description Switch1-IRF-Switch2-IRF-2/1/8
quit
interface FortyGigE 2/1/7
description Switch2-IRF-Switch1-IRF-1/1/7
quit
interface FortyGigE 2/1/8
description Switch2-IRF-Switch1-IRF-1/1/8
quit
interface Fc1/2/13
description <<nimble_system_name>> CA-fc5
quit
interface Fc1/2/14
description <<nimble_system_name>> CA-fc9
quit
interface Fc1/2/15
description <<nimble_system_name>> CB-fc5
quit
interface Fc1/2/16
description <<nimble_system_name>> CB-fc9
quit
interface Fc2/2/13
description <<nimble_system_name>> CA-fc6
quit
interface Fc2/2/14
description <<nimble_system_name>> CA-fc10
quit
interface Fc2/2/15
description <<nimble_system_name>> CB-fc6
quit
interface Fc2/2/16
description <<nimble_system_name>> CB-fc10
quit
interface Ten-GigabitEthernet 1/2/1
description <<mgmt_server_1_hostname>>-LOM1
quit
interface Ten-GigabitEthernet 1/2/2
description <<mgmt_server_2_hostname>>-LOM1
quit
interface Ten-GigabitEthernet 2/2/1
description <<mgmt_server_1_hostname>>-LOM2
quit
interface Ten-GigabitEthernet 2/2/2
description <<mgmt_server_2_hostname>>-LOM2
quit
save
Configure Global FCoE Parameters
Configuring the Fibre Channel over Ethernet (FCoE) mode requires configuring quality of service (QoS) for
Data Center Bridging Exchange on the switch. Configuring QoS for Data Center Bridging Exchange also
prevents FCoE traffic in the switch from being blocked and ensures that the FCoE traffic is lossless.
Procedure
1 On the switch, run the following commands from system-view to configure the Enhanced Transmission
Selection local precedence QoS table.
©
Copyright 2017 by Nimble Storage, Inc. All rights reserved.
Documentation Feedback
32