Select A Network Connection; Power On The Failover Manager And Configure The Ip Address And Host Name - HP StorageWorks P4000 User Manual

4. In the Storage section, right-click the datastore icon and select Browse Datastore.
5. Right-click the FailoverMgr.vmx file and select Add to Inventory.
6. In the Add to Inventory Wizard, enter a name for the new Failover Manager and click Next.
7. Select the Inventory Locations to place the Failover Manager in the Add to Inventory wizard.
8. Verify the information, and click Finish.
9. Close the DataStore Browser.

Select a network connection

1. In the Inventory Panel select the Failover Manager.
2. In the Information Panel select the Summary tab. In the Commands section, select Edit Settings.
The Virtual Machine Properties window opens.
3. On the Hardware tab, select Network Adapter 1.
4. Select the appropriate network connection from the Network label list on the right.
5. Click OK to exit the Virtual Machine Properties window.

Power on the Failover Manager and configure the IP address and host name

1. In the Inventory panel, select the new Failover Manager, and power it on using the Power On
command on the Information panel.
2. Click the Console tab, and wait for the Failover Manager to boot.
3. When the Failover Manager has finished booting, a login prompt opens.
4. Log in, and use the SAN/iQ Configuration Interface to configure an IP address and host name
for the Failover Manager.
Setting the IP address
Use the Configuration Interface to set the IP address for the Failover Manager.
1. Type start and press Enter.
2. Press Enter to log in.
3. Tab to Network TCP/IP Settings, and press Enter.
4. Tab to the network interface, and press Enter.
5. Tab to the Hostname field if necessary.
6. Press Backspace in the Hostname field to delete the default name, and enter your own host name.
This host name appears in the CMC. It does not change the name of the original FOM.vmx file,
nor does it change the name in VMware.
P4000 SAN Solution user guide 167