System Settings; Network Settings; Lan/Wan/802.1X Settings; Table 7: Network Settings - Grandstream Networks UCM6102 User Manual

This section explains
UCM6102/UCM6104/UCM6108/UCM6116. Those parameters include Network Settings, Change
Password, LDAP server, HTTP server, Email settings and Time Settings.

NETWORK SETTINGS

LAN/WAN/802.1X SETTINGS

After successfully connecting the UCM6102/UCM6104/UCM6108/UCM6116 to the network for the first time,
users could login the Web GUI and go to Settings->Network Settings to configure the network parameters
for the device depending
UCM6104/UCM6108/UCM6116. The UCM6102 supports both WAN port and LAN port, with Router or
Switch mode function configurable on the LAN port. Select each tab in the Network Settings page to
configure LAN settings, WAN settings (UCM6102 only) and 802.1X.
Please refer to the
UCM6104/UCM6108/UCM6116 and UCM6102 respectively.
Settings -> Network Settings -> LAN
IP Method
IP Address
Gateway IP
Subnet Mask
DNS Server 1
DNS Server 2
User Name
Password
Preferred DNS Server
Settings -> Network Settings -> 802.1X
802.1X Mode
Firmware Version 1.0.0.32

SYSTEM SETTINGS

configurations
on the network
following tables

Table 7: NETWORK SETTINGS

Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Enter the IP address for static IP settings.
Enter the gateway IP address for static IP settings.
Enter the subnet mask address for static IP settings.
Enter the DNS server 1 address for static IP settings.
Enter the DNS server 2 address for static IP settings.
Enter the user name to connect via PPPoE.
Enter the password to connect via PPPoE.
Enter the preferred DNS server address.
Select 802.1X mode. The default setting is "Disable". The supported 802.1X
mode are:
•
EAP-MD5
UCM6102/6104/6108/6116 USER MANUAL
for system-wide
environment. The
for the network configuration
parameters on
settings are similar
parameters
Page 23 of 108
the
for
on