Remote Data Bank Save Setting Function - Sunx FX-301 Operation Manual

8-4. Remote Data Bank Save Setting Function (FX-303 does not incorporate this function.)
This function allows the configuration settings information in an amplifier to be saved to other connected amplifiers, in a single step.
Up to 3 sets of configuration settings information can be saved into each amplifier, using '
However, in FX-301B/G/H(Blue, Green and Infrared LED types) or FX-302 units in which the optical communications settings change function has been locked, saving will not occur.
Please refer to p.41 The optical communications function
Move the Jog switch to select the desired
channel for saving, in a single step.
Channel 1
Displayed on
amplifiers on which
communication is
being done.
The digital display will blink
twice to confirm the setting.
for the direction of optical communication.
Press the MODE key
5 times.
Move the Jog switch
toward the ' ' direction
4 times.
Press the Jog switch.
Move the Jog switch
toward the ' ' direction
twice.
Press the Jog switch.
Channel 2 Channel 3
Press the Jog switch.
Select from YES/NO
by moving the Jog switch.
Press the
Jog switch.
The digital display
will scroll (twice).
FX-301B/G/H:
Channel for
saving is
displayed.
Press the MODE key 3
times or keep it pressed
for 2 sec. or more.
1 Press the [MODE key] 5 times to select 'PRO mode'.
2 Move the [Jog switch] toward the
select 'PRO4 mode'.
3 Press the [Jog switch] to enter the 'setting condition copy
setting' state.
4 Move the [Jog switch] toward the
enter the 'remote data bank save setting' state.
5 If the [Jog switch] is pressed, the digital display will blink.
6 Move the [Jog switch] to select the desired 'channel' for
saving, in a single step.
7 If the [Jog switch] is pressed, the letters '
8 If the [Jog switch] is moved, '
alternately displayed.
9If the [Jog switch] is pressed while '
digital display will scroll (twice) and the settings information
will be copied. Then '
setting.
However, for amplifiers (FX-301B/G/H or FX-302) in
which the optical communications settings change
function has been locked, '
If the [Jog switch] is pressed while '
display will return to the 'remote data bank save setting'
state.
0Press the [MODE key] 3 times or keep it pressed for 2 sec.
or more to return to 'RUN mode' (normal sensing operation).
44
' , ' ' and ' ' .
direction 4 times, to
' '
' ' direction twice, to
' will blink.
' and ' ' will be
' is blinking, the
' will blink twice, confirming the
' will blink twice.
' is blinking, the digital