Sunx FX-101 Instruction Manual

INSTRUCTION MANUAL
Photoelectric Sensor
FX-100 Series
Thank you very much for using SUNX products. Please read this Instruc-
tion Manual carefully and thoroughly for the correct and optimum use of this
product. Kindly keep this manual in a convenient place for quick reference.
WARNING
Never use this product as a sensing device for personnel protection.
In case of using sensing devices for personnel protection, use products
which meet laws and standards, such as OSHA, ANSI or IEC etc., for
personnel protection applicable in each region or country.
1
Operation indicator
(Orange)
Digital display (Green)
(Threshold value)
2

MOUNTING

2. Press down the rear part of the mounting
it.
hook on the rear portion of the mounting section is likely to break.
Use M3 screws with washers for mounting.
less.
1. Snap the fiber lock lever down, till it stops
completely.
2. Insert the fiber cables slowly into the inlets
until they stop. (Note 1)
tion, till it stops.
it is inserted.
the sensing performance will deteriorate.
Digital Fiber Sensor
MJE-FX100 No.0007-43V
ON key / OFF key /
Set value UP key Set value DOWN key
MODE key
Digital display (Red)
(Incident light intensity)
ON key /
Set value UP key
2
1
35mm width DIN rail
1
2
3
1
Fiber lock
lever
-
2
Fiber
or
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
3

WIRING

Insert the cable with connector
this product's connector area as shown in the
right figure.
Pressing the release lever of the cable with con-
nector, pull out the connector.
Note: Take care that if the connector is pulled out without
pressing the release lever, cable or connector may
break.
Connector pin No.
1
2
3
4
Connector pin No.
8V
Internal circuit
Connector pin No.
-
Internal circuit
*1
Non-voltage contact or NPN open-collector transistor
5
When turning ON the power, the product name is indicated on the green
digital display, while the emission frequency is indicated on the red digital
display. Then switches into RUN mode [digital display (green: threshold
value, red: incident light intensity)].
M3 screw
with washer
is indicated on the green digital display after inputting the first point.
sec. In case of lighting up the digital display again, press any key for 2
sec. or more.
value. (Hold down the key to make the value change faster.)
The threshold value is stored after 3 sec.
, insert the
Terminal name
1 +V
2 Output
3
4 0V
Color code of cable with connector
(Brown) +V
Load
(Black) Output
100mA max.
(White) External input
*1
(Blue) 0V
Users' circuit
Color code of cable with connector
(Brown) +V
*2
(White) External input
100mA max.
(Black) Output
Load
(Blue) 0V
Users' circuit
*2
Non-voltage contact or PNP open-collector transistor
or
<When turning ON the power> <RUN mode>
Automatic
Product Emission Threshold
name frequency value
<When in RUN mode>
Threshold Incident light
value intensity
Cable with
connector
into
CN-14A-C
Release
lever
+
12 to 24V DC
±10%
–
+
12 to 24V DC
±10%
–
or
Incident light
intensity
-