Setting Condition Copy Function - Sunx FX-301 Operation Manual

8-2. Setting Condition Copy Function (FX-303 does not incorporate this function.)
By utilizing the optical communications function, the settings information from the operating amplifier can be
copied to other connected units. (Except for data bank contents) However, the 0-Adjust function will not be
copied. However, in FX-301B/G/H(Blue, Green and Infrared LED types) or FX-302 units in which the optical
communications settings change function has been locked, copying will not occur.
Note) It is not possible to transmit the settings information from the setting condition copy function between
FX-301(Red LED), FX-301B/G/H(Blue, Green and Infrared LED types) and FX-302 units. Therefore, if units of
both models must be utilized when connected together, then similar models should be connected side by side.
Please refer to p.41 The optical communications function
Also displayed on
amplifiers on which
copy is done
The digital display will blink twice to confirm the setting.
Press the MODE key
5 times.
Move the Jog switch
toward the ' ' direction
4 times.
Press the Jog switch.
Press the Jog switch.
Select from YES/NO
by moving the Jog switch.
Press the Jog
switch.
The digital display
will scroll (twice).
Press the MODE key 3
times or keep it pressed
for 2 sec. or more.
for the direction of optical communication.
1 Press the [MODE key] 5 times to select 'PRO mode'.
2 Move the [Jog switch] toward the
select 'PRO4 mode'.
3 Press the [Jog switch] to enter the 'setting condition copy
setting' state.
4 If the [Jog switch] is pressed, the digital display will blink.
5 If the [Jog switch] is moved, '
alternately displayed.
6If the [Jog switch] is pressed while '
digital display will scroll (twice) and the settings information
will be copied. Then '
setting.
However, for amplifiers (FX-301B/G/H or FX-302) in
which the optical communications settings change
function has been locked, '
If the [Jog switch] is pressed while '
display will return to the 'setting condition copy setting'
state.
* When communication error has occurred, '
displayed.
Confirm that all amplifier units are properly connected to
each other.
7 Press the [MODE key] 3 times or keep it pressed for 2 sec.
or more to return to 'RUN mode' (normal sensing operation).
42
direction 4 times, to
' '
' and ' ' will be
' is blinking, the
' will blink twice, confirming the
' will blink twice.
' is blinking, the digital
' will be