Timer Setting Function (Fx-301 , Fx-303) - Sunx FX-301 Operation Manual

5-3. Timer Setting Function (FX-301 , FX-303)

Four different timer operations can be selected; Without timer, OFF-delay,
ON-delay, ONE-SHOT .
The range of available timer delays is 0.5 ms to 500 ms.
However, the increments available for timer delays will vary, depending on
the timer period, as shown in the table on the right.
Without OFF-
timer delay
Select the desired timer operation
by moving the Jog switch.
Select the desired time period
by moving the Jog switch.
The digital display will quickly
blink 3 times to confirm the setting.
Press the MODE
key 5 times.
Move the Jog switch
once, toward
the ' ' direction.
Press the
Jog switch.
Move the Jog switch
once, toward
the ' ' direction.
Press the
Jog switch.
ON- ONE-
delay SHOT
Press the
Jog switch.
Press the
Jog switch.
Press the MODE key 3
times or keep it pressed
for 2 sec. or more.
25
Timer period
0.5 ms,1 to 30 ms
30 to 100 ms
100 to 500 ms
1 Press the [MODE key] 5 times to select 'PRO mode'.
2 Move the [Jog switch] once toward the '
to select 'PRO1 mode'.
3 Press the [Jog switch] to enter the 'response time change' state.
4 Move the [Jog switch] once toward the '
to enter the 'timer setting' state.
5 If the [Jog switch] is pressed, the current timer
operation will be displayed.
* The factory setting is Without timer.
6 If the [Jog switch] is moved, the digital display will blink.
Select the desired timer operation.
* The factory settings allow timer operation to be switched
using timer operation setting mode, between Without
timer and 10 ms OFF-delay, when in 'NAVI mode'.
When set to '15 ms ON-delay', the selected timer
function can be: Without timer / 15 ms ON-delay.
7 Press the [Jog switch] to enter the 'timer setting selection' state.
* The factory setting is 10 ms.
8 Select the desired timer period by moving the Jog switch.
* Timer period will be switched to the values set by timer
operations, unless 'Without timer' is chosen.
Example: If the time was initially set to '500 ms OFF-delay'
and this was subsequently switched to
'ON-delay', then '
setting the time.
9 If the [Jog switch] is pressed, the digital display will quickly
blink 3 times, confirming the setting.
0 Press the [MODE key] 3 times or keep it pressed
for 2 sec. or more to return to 'RUN mode'
(normal sensing operation).
Delay increments
1 ms increments
5 ms increments
10 ms increments
' direction,
' direction,
' would be displayed when